SNMP problem

[Anon]

After enable extensions 'php_snmp.dll' in WinNT IIS 4.0, I get the following error at the end of all .php page,

Cannot find module (IP-MI😎: At line 0 in (none) Cannot find module (IF-MI😎: At line 0 in (none) Cannot find module (TCP-MI😎: At line 0 in (none) Cannot find module (UDP-MI😎: At line 0 in (none) Cannot find module (SNMPv2-MI😎: At line 0 in (none) Cannot find module (SNMPv2-SMI): At line 0 in (none)

Thanks a lot!

[Anon]

Hi Stan,

I have the EXACT same problem. I hope somebody could solve this matter. I installed the 4.0.4pl1 and still it's there. I've been searching for an answer for about 3 weeks now and all that shows up is NULL....

I hope you or somebody else has solved this matter and could tell me/us HOWTO.2..

Regards, Harro

[Anon]

I have found a solution for this problem, create a directory '\usr\mibs' at the root of the same drive as the extracted php sources. Then, copy all MIBs files in the php sources to that directory.

Good luck.

Rgds.
Stanley

[Anon]

This fix doesn't work on my system, I created the folder (in this case C:\usr\mibs") and copied the -MIB.txt files from the \php\mibs folder but I am still getting the same errors.

[Anon]

Sorry for confusing you, I mean copy all files under '\php\mibs' to 'c:\usr\mibs'. I hope it will fix your problem. Good luck.

Rgds.
Stanley

[Anon]

That's what I did and I still have the problem.

What did I wrong ?

Thanks

[Anon]

Hi. Thnaks a lot! I do as you said and my problem has gone!!

thank you very mach !

Hikaru.

[Anon]

I had the same problem only I happen to install PHP at D:\PHP.

Copying mibs to D:\usr\mibs\ did NOT work but
copying them to c:\usr\mibs\ DID work.

Possibly because C:\ is where IIS is installed?

-Mike